Static and Thermal Analysis of Turbine Blade of Turbocharger

• Kamlesh Bachkar
• W.S. Rathod

ANSYS, FEA, INCONEL 718, Turbine blade, SolidWorks

This paper borders around analysis of turbine blade. The blade is a rotating part which converts kinetic energy into mechanical energy. Turbine blade is critical part of turbocharger which has shown increasing growth of failure damaging turbine disk. It deals with Static and thermal analysis of turbine blade which is made up of INCONEL 718 to estimate its performance. The causes of failure for turbine blade have also been found out. The investigation has been done using SoildWorks 2012 and ANSYS 10.0 software. SolidWorks 2012 is used for modeling of turbine blade and analysis has been done by ANSYS 10.0 software. An attempt has been made to investigate the effect of induced stresses, pressure and temperature on the turbine blade. A structural analysis has been carried out to investigate the stresses and displacements of the turbine blade. A thermal analysis has been carried out to investigate the thermal gradient and thermal stress.

Published

 Vol. 2 Issue. 2 Pages. 2648-2654

Kamlesh Bachkar, W.S. Rathod. "Static and Thermal Analysis of Turbine Blade of Turbocharger".INTERNATIONAL JOURNAL OF ENGINEERING DEVELOPMENT AND RESEARCH ISSN:2321-9939, Vol.2, Issue 2, pp.2648-2654, URL :https://rjwave.org/ijedr/papers/IJEDR1402213.pdf

Volume 2 Issue 2 

Pages. 2648-2654

Published Paper PDF : https://rjwave.org/ijedr/papers/IJEDR1402213.pdf

Published Paper URL : https://openrgate.org/viewfulldetails.php?id=779

This work is licensed under a Creative Commons Attribution 4.0 International License and The Open Definition